for Large Picture
for Large Picture
to Previous Section
Inland DB-100 Glass Band
A Good Hobbyist Level
The DB-100 Bandsaw is a hobbyist
level diamond bandsaw. The DB-100 is primarily designed for use
on glass, stained glass, fiberglass or plastic. The diamond
bandsaw can also be used to cut thin "tile thickness"
pieces of ceramic, marble, or stone. However, for prolonged
cutting of these heavier materials, a more powerful, professional
level saw should normally be used.
The DB-100 has an innovative
design with many advanced features. A unique 'Flow-Through'
coolant system applies coolant to the upper blade guide allowing
the water to flow down the blade while a lower drain removes
used coolant. The Coolant reservoir contained in the upper
housing holds about 1/2 liter of water.
A replaceable "BladeSert"
blade guide fits into the table and provides support to the blade
where it is needed - at the point where all the cutting is done.
The Inland DB-100 Bandsaw has a direct drive variable speed motor
that provides plenty of power for hobbyist to cut intricate and
The Inland DB-100 diamond bandsaw
Includes two seamless stainless steel diamond blades. Variable
speed 110 volt ac with grounded plug. Two year manufacturer's
warranty (excluding blade).
SPECIAL - Each Saw Includes
TWO diamond Blades!
Frame: Heavy Construction Grade Plastic
Motor: 1/10 hp, 110 vac, Variable Speed (0-3,000rpm)
Motor Torque: 48 oz-inches
Blade Speed: Variable 0 - 800 inches per second
Case Size: Height 18", Weight 9 lbs
Table Size: 11" x 9" Aluminum
Lubrication: Gravity feed, 1/2 liter reservoir
Throat Depth: 5" Upper Blade Guide:
Up To 4-1/2"
Mfgr Warranty: Two Years (excl. blade)
Warning: Inland will not honor the warranty
item if it is used with salt water.
- Mfgr reg price $315 On-Line SALE $209.75!
Out of Stock - No Backorders
TL-368 Inland DB-100
Bandsaw ......................................... 209.75
Inland DB-100 Accessories - Scroll Down